View Full Version : C clip
hiram
12-29-2011, 04:09 PM
Where can I get the 'C' clips for the Mihec mold pins?
longbow
12-29-2011, 04:38 PM
I am sure Miha would mail you some if you asked.
Alternately, you could measure the pin and these C clips will likely be metric standard so you could look them up on the internet at a supplier. For example, if the pin is 2.5mm the C clip is likely going to be standard for 2.5mm diameter pin.
If you have lost C clips, I find that using a small magnet while changing pins keeps C clips from disappearing. I put a large round magnet of about 3/4" diameter onto the side of the mould then pop off the C clips which jump directly to the magnet which hangs onto them. When I install the new pins I just use small needle nose pliers to pull C clips off the magnet and relocate into grooves then snap in place.
Longbow
winelover
12-29-2011, 04:45 PM
http://castboolits.gunloads.com/showthread.php?t=81199
See last post. Check with Zbench.
Winelover
stubshaft
12-29-2011, 08:31 PM
You can try an Auto Parts store.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.