Cleaning with JB "bright"??

[Wayne S]

After the usual bore cleaner, brass brush's and wet & dry patch's that come out clean, I coat a tight patch or a bore brush with JB's "Bright", after just one pass through the bore, a patch comes out looking like a coal mine. I've "scrubbed" the bore, cleaned, and get clean patch's . Only to scrub with JB Bright again and again get the black patch's . [smilie=b: Anyone have any ideas what is going on ??

[btroj]

Take a patch, put the JB on it, run it on the outside of the barrel where itis spotless. It will turn black.

Ypu will never get a patch with JB to come out clean so don't sweat it.

[selmerfan]

btroj hit the nail on the head.

[gwpercle]

stop beating your head against the wall. For some reason JB does this , turns the patch black. Here is what do - use the JB first then finish cleaning with bore cleaner and follow up with a lightly oiled patch. If the last patch comes out with any black streaks go again with bore cleaner and oily patch

[zomby woof]

Don't sweat it. That's what is does.

[Three44s]

The black you are seeing is the JB after it's gotten broken down.

Three 44s

[44man]

I never used any but have used some of the lead remover patches. They get black too and I think it is steel being removed with the abrasive.