Are we ready for a Rerun; 247g Whisper/Blackout?

[castblaster]

I want one. And I'm gona hold my breath till I get one.


Matt Hooper

[speedyr]

I'll take one if they rerun them...

probably a 3 cavity if it matters..

[vondelta]

I would like a 4 or 5 cavity mold !!!

[blasternank]

I want one as well. 4-5 cavity!!

[SwedeNelson]

One more and we can get it started as a SGB
Schedule is booked in to August.

Swede Nelson

[Idaho Sharpshooter]

Make more this time...

Rich

[castblaster]

Im going to suffocate befor aug. But that's about when my "form 1" may get approved.


Matt Hooper

[haus]

I am interested. I'm new so I would like to know the expected price. Thanks

[Texinoz]

I also am interested. Can you remind me of the boolit dimensions? I wish to use it in a 303 barrel - so I would like it at .311 to .313 rather than .308... (2 or 3 cav mold.)
Mark

[Texinoz]

Ok, I quit being lazy and looked-up the original thread for specs etc.
I am in for a 3 cavity - 1pb 2gc with a hollow point on one of the gcs please.
Love it! Mark

[castblaster]

Swede, do we have enough to go active?


Matt Hooper

[greywuuf]

ok last time i got a 2 pb 2 gc , but it looks like I am going to try to use the PB's mostly only my HP is a gc. maybe I ought to get another with a HP pb

put me down for another ... I will decide what configuration I want when it goes live ...

[greywuuf]

and that looks like 6 .. maybe 7
depending on the time frame I might be good for two
how many do we need to Not be a small group buy ?

[SwedeNelson]

Group buy is started and on the schedule
http://castboolits.gunloads.com/showthread.php?p=1464848#post1464848

Thanks
Swede Nelson

[Bert2368]

Is there a "results" thread? There's half a dozen of us in the "want to buy" section trying to get samples before we sink on a mould... Someone could make a few $'s helping us figure out if these will be the best thing since sliced bread (or not).
http://castboolits.gunloads.com/showthread.php?t=145597

[jimgun]

hello, I realize this buy is just about closed, but i have a question. has anyone used this in anything bigger than a whisper? what twists and velocities are we looking at here? my concerns are most of my 30 cal, which include naturally a 300 whisper, 30 herretts, 300 savages, 308, 06, are all 1/10 twist. It should stabalize in the whisper and herrett, but what about the faster stuff? thanks jim

[Moonie]

I have used the Accurate Molds version of this boolit in my 30-06 at 1950fps (35gr H4895), it is a Savage with 1-10" holes at 100 and 200 are perfectly round.

[johnfl]

I have not found much detail in the "results" thread..... I would be interested in more detailed range reports using both ARs and bolt guns...... Accuracy along with loads geared toward higher fps in .308 or 30-06.....

Thanks

[johnfl]

Bump..... Anyone with more detailed results to post???