View Full Version : Home Made Collet Puller
Hase anyone done this yet? I have some ideas but I'd need to fab up a section of an extra ram or some pipe to pass through the top of the press. I should mention that these are hand offs from a friend who PCS'd and I'm not intrested in reloading the bullets they will be going in the pot.
dragonrider
10-28-2011, 04:05 PM
If you are not going to reuse them just use a pair of channel lock plier and grab the boolit above the press and then lower the ram, simple and effective.
Ziptar
10-28-2011, 05:19 PM
Wire cutter works good too.
Pete P
10-28-2011, 08:30 PM
I have the Hornady, It works well, damages my lead boolits, O well back in the pot.
Freightman
10-29-2011, 01:15 PM
Nice thing about lead, it can be reused.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.