dskjeie
10-13-2011, 08:06 PM
I was wondering if anyone uses the lee hand press with the lee sizers.
Any info like if it works esaly or is tough to opperate
would be sizing TL358-158SWC that are dropping at an avg of .358
Not sure if I should size to .358 or. 357
Wanting to size do to there being a "fin" at the bottom of tye boolit. Seems the spure plate has a bit of a gap every now and then. Tried to tighten spure plate bolt but it will not move ether way.
thanks for all the help over the last month guys, you all have been informative and warm welcoming.:drinks:
Any info like if it works esaly or is tough to opperate
would be sizing TL358-158SWC that are dropping at an avg of .358
Not sure if I should size to .358 or. 357
Wanting to size do to there being a "fin" at the bottom of tye boolit. Seems the spure plate has a bit of a gap every now and then. Tried to tighten spure plate bolt but it will not move ether way.
thanks for all the help over the last month guys, you all have been informative and warm welcoming.:drinks: