View Full Version : 8mm Version of 311365???
101VooDoo
10-06-2011, 11:43 AM
Swede thinks he can do a version of the 311365 in 8mm with current tooling, any interest in a mould that drops a boolit that will size to .325?
Boolit weight and shape seem like a natural for the 8mm; wouldn't hit NOE's schedule until about May or June.
Pics of the current version:
Blammer
10-06-2011, 04:14 PM
oooooooooooooooo!
I like that idea!
I may be up for a 2C +HP. :)
phaessler
10-06-2011, 05:34 PM
I would definently be in for a 2cav.
Pete
shawnsmc
10-06-2011, 08:01 PM
That is a great idea put me down for a 5 cavity 2PB 3GC with HP in one of the GC cavities.
Idaho Sharpshooter
10-06-2011, 09:48 PM
Sign me up! Especially if he can do two diameters. I have a 1904 Haenel 7.92x57 that a boolet that dropped at .321" would be perfect.
Rich
Hardcast416taylor
10-07-2011, 01:12 AM
How many moulds do we need for this group buy? I`d be in for a 2 cavity.Robert
Landric
10-07-2011, 03:24 PM
I'd be in for one.
Blammer
10-07-2011, 04:08 PM
101voodoo, graciously allowed me to be the honcho. :)
I'll also sell 8mm GC's with it for those who want so you can save shipping.
One diameter will be ran. If we do two dia we'll have to have seperate buy for it.
I'll contact NOE and see how many we need for this to happen.
Blammer
10-07-2011, 04:13 PM
It takes 5! I'll get a new thread started in the GB section.
How is the .30cal. version of this bullet shooting at Hi-Vel. ? (over 2000fps+)
Blammer
10-07-2011, 04:31 PM
Current sign up thread
http://castboolits.gunloads.com/showthread.php?p=1422187#post1422187
my results of the 30 cal version
http://castboolits.gunloads.com/showthread.php?t=128286
rtracy2001
11-20-2011, 02:17 PM
Do we have a drawing/estimated weight of the 8mm version yet? Looking for a Boolit for Elk in my 8mm06.
I would be in for a 2 cavity.
dromia
11-25-2011, 05:28 PM
You need to sign up on the active GB see Blammers post, number 11.
X-man
08-20-2012, 08:41 PM
I just picked up a new M-48A Yugoslavian Mauser. I'm wondering if this mould or the 8mm SIL design in the Mihec group buy will work better?
dodgyrog
08-21-2012, 01:17 AM
I love this design and have them for sizing to .310 and to .315. The down size is the 'fins' I get on the boolit noses. The fins scrape off with my finger nail but it is a pain in the rectum.
It's the only boolit design that gives me this problem and I do have a lot of NOE moulds.
I'll have to think for a while before ordering the 8mm version.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.