Timb1
01-30-2007, 03:23 PM
I was casting some 200gr .431 boolits out of a lee mold and noticed that I was not getting full fill out until the mold got hot enough to produce frosty boolits. I was running the pot at 700 degrees. I know frosty boolit are not a bad thing but I would like to make nice shiney ones also. I was wondering if I should just turn the pot up or through some more tin in the mix. How much tin is needed to allow me to turn the heat down or at least keep the mold cooler?
Thanks Tim.
Thanks Tim.