View Full Version : Sprue plate stop pin, RCBS
Longone
09-15-2011, 07:25 PM
How is that pin installed in an RCBS mold? Is it a press fit?
Longone
deltaenterprizes
09-16-2011, 04:58 AM
Press fit with straight knurl on pin.
Longone
09-16-2011, 05:50 AM
Thanks deltaenterprizes,
I have a mold that the blocks are worn at the pivot pin bolt and needs to be faced off.
Longone
deltaenterprizes
09-16-2011, 09:14 AM
I grab the pin with vise grips and leave a space to insert a flat blade screwdriver and use the screwdriver to pry up on the vise grips to remove the pin. A little tap will reinstall the pin.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.