32-20 neck sizing die

[calkar]

If anyone would care to open up the body of 2 lee 32-20 full length sizing dies for me I would greatly appreciate it, and would pay for your time. I and some other cowboy silhouette shooters are tired of over working our brass and would love to just neck size them. If I can find someone to do it, I guess I would ask Lee Precision to send two new 32-20 full length sizing dies directly to you. Any suggestions would also be appreciated. Thanks!

[deltaenterprizes]

PM sent.

[calkar]

pm answered, Thanks

[leftiye]

Why not just short size them? Anything that doesn't get the shoulder will have virtually the same effect. Alternatively, size the neck only with a straight wall die, say .32S&W.

[4060MAY]

I tried to have LEE make a collet die for the 32-20, but their collet die will only work with a case length no shorter than the .22hornet, because of the slits in the collet

I greatly modified a 7.62 x 39 die set to load 32-20, a lathe is required..

If you want the pictures of how I did it, PM and I'll send them to your personal email, 6-7 picture IIRC and I don't want to take up the bandwidth on this site, or I would just post them

[LazyJW]

Try using a 32 H&R Mag carbide die. No lube needed.

[calkar]

short sizing is what I wanted to do, but the body of the case starts to be sized within the first 1/2" of insertion, way before the neck has been touched. Im going to try a .32 straight walled carbide die , that was a great idea, Thanks!!

[square butte]

How bout a lyman 310 sizing die for 32-20. Pretty sure they are only neck sizers. Find youself a set of handles and a set of 310 dies for 32-20.

[calkar]

I just may have to go with the 310.

[Wayne Smith]

How bout a lyman 310 sizing die for 32-20. Pretty sure they are only neck sizers. Find youself a set of handles and a set of 310 dies for 32-20.

Or pick up TrueLine Jr off eBay. The last couple I saw went cheap.

[leftiye]

Bore out the die to the base of the neck. Maybe a taper pin reamer?

[bowhunter]

on the 310 die they make an adapter to screw into your 7/8 threads of your press so that they can be used.

[square butte]

Looks like C & H tool and die can make you a neck sizing die too. Looks like about $29 or so