7.35 carcano

[odfairfaxsub]

i need some help with those bullet molds you use. i don't have one and could use your help on a mold or maybe deminsions or ......... perhaps what your doing.

[JeffinNZ]

Jim at CBE in AU does a mould for the 7.35mm.

www.castbulletengineering.com

[Pavogrande]

are you looking for a mould or mould info ? -- the mould I used is lyman 300136 a 146gr round nose gas check --
fairfax cnty = mt vernon area

[leadhead]

I have that same mold 300136 but useing a 7mm gas check on
a 30 cal bullet just doesn't make any sense to me.
That puts the base of the bullet smaller than the bands, which is not
good. I get alot of gas cutting and blow by with this setup.
I run cast 30 cal 150 gr thru a .301 push thru die and it works great.
Denny

[mooman76]

I have a Lyman mould that drops .301 that I would think was for this round but the mould is marked 243 on it so I assume it was recut special order for someone.

[odfairfaxsub]

yeah looking for a person or company who can do me a .301 push die. is buckshot cheaper than lee? yeah looking for either mold data or a mold. i can type the digits in and they can make it or someone in america can sell me one (store or company or indv)

that is still made, not the type oh i have one o by the way don't look for it because they stopped making it 10 years ago lol.

[leadhead]

Got mine from Buckshot......Really great workmanship.

Good price and fast shipping.
Denny

[NickSS]

I have an NEI mold that casts a 140 gr 301 bullet and I use a lee push through sizer works well for me.

[odfairfaxsub]

right on. since i got this gun two freakin 6.5s came at me. a carbine and a long rifle. both each cost me 175 dollars a piece. can't believe it!!!