View Full Version : cerrasafe
adrians
07-31-2011, 10:25 AM
here's a tip,,,,,,,
don't get it in the locking lug area!!!:twisted::groner:[smilie=b:[smilie=b:[smilie=b::groner::evil:.
you live and learn, sometimes the hard way:roll:
redneckdan
07-31-2011, 10:56 AM
It does shatter pretty easily. Take a blade screw driver and hit the center of the casting, should shatter off the locking lug spill over.
timbuck
07-31-2011, 11:29 AM
Use a pencil tip electronics soldering iron to cut/melt sections out and then pick the rest out. It worked well for me.
shotman
07-31-2011, 12:07 PM
I made some cast boolits once. I dont know what happened. they never made it to target
adrians
07-31-2011, 09:40 PM
thanks guys ,,,
all i can say is my heat gun paid it's rent on this effort[smilie=l:.
second time around i was watching my pouring like a hawk'
hum!!!! cerrosafe boolits , sounds like a good close range splasher gun,, hot ,,,hot ,,hot.:evil::holysheep:twisted:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.