Johnch
07-29-2011, 08:58 PM
Tonight I finaly did it
I was checking shotgun steel shot loads
I shot not the suport rods ( I long ago replaced them with wood dowels )
I shot the defusers , blew both to pieces
Can't even blam it on someone else
So I though a min and went Redneck :redneck:
I grabbed a cardboard box
Cut the top out and duct taped a white garbage bag over it
I then cut a opening at each end about the same as the sky screens
I then sat the Cronny and the low shot boolit deflector inside
Put the whole thing on the table and started shooting
The box started to slide a little from the muzzel blast , so I ducted it to the table
But I think I will make a better deflector out of a piece of 6x6x1/2 angle iron and weld it to some 3/16 to set the cronny on
That should be heavy enough to keep the box from moving
It works perfictly so far
And if I happen to hit the box or bag ..........Oh well
I have more
And they are cheap compared to new defusers or rods
John
I was checking shotgun steel shot loads
I shot not the suport rods ( I long ago replaced them with wood dowels )
I shot the defusers , blew both to pieces
Can't even blam it on someone else
So I though a min and went Redneck :redneck:
I grabbed a cardboard box
Cut the top out and duct taped a white garbage bag over it
I then cut a opening at each end about the same as the sky screens
I then sat the Cronny and the low shot boolit deflector inside
Put the whole thing on the table and started shooting
The box started to slide a little from the muzzel blast , so I ducted it to the table
But I think I will make a better deflector out of a piece of 6x6x1/2 angle iron and weld it to some 3/16 to set the cronny on
That should be heavy enough to keep the box from moving
It works perfictly so far
And if I happen to hit the box or bag ..........Oh well
I have more
And they are cheap compared to new defusers or rods
John