Texasflyboy
07-28-2011, 06:25 PM
A hollow-point conversion by Erik Ohlen at Hollow Point Bullet Molds (http://www.hollowpointmold.com/).
I purchased this two cavity #34 plain base a month or so ago on eBay. I've been wanting a two cavity hollow point conversion for some time, more than 10 years it seems, and the two cavity #34's seem to be hard to find. My thoughts were that a two cavity mould in .45ACP wasn't a popular item back in the San Diego days. Four cavity and sizes larger seem to be much more prevalent.
I sent it to Erik about two weeks ago and requested both cup point and 5 star hollow point pins. I initially requested Erik's inset bar design, but he politely pointed out to me that one of the block alignment pins would be in the way, so he made it a Cramer Style conversion instead. The upper guide pin on both pins is captured in the block, the other pin slides out. The upper pin acts as a fixed guide.
Here are the photos as of today. I received the mould Monday and won't be able to cast with it anytime in the near future, but wanted to share what I had.
I will update the thread once I cast with the mould and figure out weight and an accurate load.
Here is the mould as I received it:
http://hgmould.gunloads.com/34PBHP/34HP12.jpg
Before and After Photos:
http://hgmould.gunloads.com/34PBHP/34HP10.jpg
http://hgmould.gunloads.com/34PBHP/34HP11.jpg
And the rest of the photos:
http://hgmould.gunloads.com/34PBHP/34HP3.jpg
http://hgmould.gunloads.com/34PBHP/34HP5.jpg
5 Pointed Star Pins:
http://hgmould.gunloads.com/34PBHP/34HP2.jpg
Cup Point Pins:
http://hgmould.gunloads.com/34PBHP/34HP13.jpg
I purchased this two cavity #34 plain base a month or so ago on eBay. I've been wanting a two cavity hollow point conversion for some time, more than 10 years it seems, and the two cavity #34's seem to be hard to find. My thoughts were that a two cavity mould in .45ACP wasn't a popular item back in the San Diego days. Four cavity and sizes larger seem to be much more prevalent.
I sent it to Erik about two weeks ago and requested both cup point and 5 star hollow point pins. I initially requested Erik's inset bar design, but he politely pointed out to me that one of the block alignment pins would be in the way, so he made it a Cramer Style conversion instead. The upper guide pin on both pins is captured in the block, the other pin slides out. The upper pin acts as a fixed guide.
Here are the photos as of today. I received the mould Monday and won't be able to cast with it anytime in the near future, but wanted to share what I had.
I will update the thread once I cast with the mould and figure out weight and an accurate load.
Here is the mould as I received it:
http://hgmould.gunloads.com/34PBHP/34HP12.jpg
Before and After Photos:
http://hgmould.gunloads.com/34PBHP/34HP10.jpg
http://hgmould.gunloads.com/34PBHP/34HP11.jpg
And the rest of the photos:
http://hgmould.gunloads.com/34PBHP/34HP3.jpg
http://hgmould.gunloads.com/34PBHP/34HP5.jpg
5 Pointed Star Pins:
http://hgmould.gunloads.com/34PBHP/34HP2.jpg
Cup Point Pins:
http://hgmould.gunloads.com/34PBHP/34HP13.jpg