robertbank
01-14-2007, 11:57 AM
Well I have a Dillon Conversion kit orderd and should be here in 10 days. Now I have some decisions to make regarding dies.
I am looking at RCBS Full length Sizing and Seater Dies as I have a couple of hundred once fired IVI brass from other rifles.
I have heard good things about Lee Collet Neck sizing dies. I would be interested in hearing your experiences with them vs standard RCBS Neck sizing die.
Also on order will be a Lee Universal Neck Expander.
The issue comes down to cost + postage. I am hoping to order all from Graff & Co to reduce postage.
As for molds I am going to be ordering a Lyman 314299 mold and either RCBS or Lyman resizing dies in 313 and 314.
Beginning to think the rifle was the least expensive part of this shooting project.:-D
Take Care
Bob
I am looking at RCBS Full length Sizing and Seater Dies as I have a couple of hundred once fired IVI brass from other rifles.
I have heard good things about Lee Collet Neck sizing dies. I would be interested in hearing your experiences with them vs standard RCBS Neck sizing die.
Also on order will be a Lee Universal Neck Expander.
The issue comes down to cost + postage. I am hoping to order all from Graff & Co to reduce postage.
As for molds I am going to be ordering a Lyman 314299 mold and either RCBS or Lyman resizing dies in 313 and 314.
Beginning to think the rifle was the least expensive part of this shooting project.:-D
Take Care
Bob