Who can recut a Lyman 4 cavity mould block?

[madcaster]

I have a 4 cavity .357 SWC design,and I am thinking:twisted: sure would be kinda nice to have a 4 cavity #375449 on these blocks!
So what are your thoughts on who could do a good acceptable job and if this is a good idea?
Thanks,
Jeff.

[LAH]

When Walt Melander (NEI) was living, he would do such as that. He recut some rejects as customer returned and sold them to me.......Creeker

[45 2.1]

I have a 4 cavity .357 SWC design,and I am thinking:twisted: sure would be kinda nice to have a 4 cavity #375449 on these blocks!
So what are your thoughts on who could do a good acceptable job and if this is a good idea?
Thanks,
Jeff.

You will have a problem doing that. The lube grooves on the 375449 will be in the low 350's in diameter while the boolit is about 358. If the profiles don't match the available cutting surface, you won't end up with a useable boolit.