ExMachina
07-12-2011, 12:53 PM
I just got my (first two) bullet molds.
When closed, there's a noticeable difference between the two molds--one shows a gap at the nose of the bullet (and other places as well) and the other mold does not. I'd say that the gap at or below 0.005".
Is this normal?
Like I said, these are my first molds so I have nothing to compare them to--all I know is that one shows a gap and the other doesn't. If the gap should not be there, I'd rather just exchange the unused mold with Midway now, rather than try to exchange a used mold w/ RCBS later.
Thanks for any advice!
When closed, there's a noticeable difference between the two molds--one shows a gap at the nose of the bullet (and other places as well) and the other mold does not. I'd say that the gap at or below 0.005".
Is this normal?
Like I said, these are my first molds so I have nothing to compare them to--all I know is that one shows a gap and the other doesn't. If the gap should not be there, I'd rather just exchange the unused mold with Midway now, rather than try to exchange a used mold w/ RCBS later.
Thanks for any advice!