View Full Version : Martini Action
drhall762
07-12-2011, 11:15 AM
I am in need of some information. I have a Martini Action (only) that is stamped Greener Conversion. (I believe it needs to be built into a complete rifle. LOL) On the top of the receiver, at the very rear, there are 4 holes. From pictures I have seen it looks as though a receiver mounted sight was there.
Can anyone tell me about these rear sights. Brand name, source, etc.
Any information is welcome.
Thanks,
Not enough info to go on. Will need a couple pictures and a few measurements. Could have been drilled and tapped at any time for any number of reasons.
Boz330
07-12-2011, 12:44 PM
There were a couple Parker Hale sights used on the small frame Martini actions but they usually used just 2 holes. The sight straddles the rear curvature of the stock receiver.
Bob
drhall762
07-12-2011, 01:29 PM
Boz,
That's where this one goes. I went to do photos and it seems to be MIA. It's here somewhere. I'll find it. Not fully settled after the move.
Go to assra. com (American Association of Singleshot Shooters) and ask your question-you'll get an answer quickly.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.