Martini Action

[drhall762]

I am in need of some information. I have a Martini Action (only) that is stamped Greener Conversion. (I believe it needs to be built into a complete rifle. LOL) On the top of the receiver, at the very rear, there are 4 holes. From pictures I have seen it looks as though a receiver mounted sight was there.

Can anyone tell me about these rear sights. Brand name, source, etc.

Any information is welcome.

Thanks,

[Reg]

Not enough info to go on. Will need a couple pictures and a few measurements. Could have been drilled and tapped at any time for any number of reasons.

[Boz330]

There were a couple Parker Hale sights used on the small frame Martini actions but they usually used just 2 holes. The sight straddles the rear curvature of the stock receiver.

Bob

[drhall762]

Boz,

That's where this one goes. I went to do photos and it seems to be MIA. It's here somewhere. I'll find it. Not fully settled after the move.

[wch]

Go to assra. com (American Association of Singleshot Shooters) and ask your question-you'll get an answer quickly.