Help

[Don 3]

I am looking for a mold or bullets for the 7.35 italian. Lyman used to make a mold #300136 but no more. These are a .299 or .300 diamater bullet.

Thanks Don

[castalott]

I 'think' that mold in double cavity sold last week on ebay. It was listed as a mold for that rifle and as that size bullet. It was the only one I've seen in for that caliber in several years....

[Don 3]

It's not going to be easy. I would buy bullets if someone cast them but noone seams to have this mold. Then you can't find a sizer but I can get one of them made. I might go that root and try to size down some .308.

Thanks for your help, Don

[Scrounger]

Someone else (apparently) was looking for a mold in that caliber a couple of weeks ago. Here's a link to that thread. It will be worth your while to read it. Some other members do have that mold and may be persuaded to sell you some bullets.

http://castboolits.gunloads.com/showthread.php?t=11368&highlight=7.35+carcano

[versifier]

Did you ask Bullshop?

[crazy mark]

I have that mould in SC but am looking for an equal hard mould to get mould. A 311440 150 gr RFN. Mark

[9.3X62AL]

One idea that occurs to me (it DOES happen every so often) would be find a 7.35 Terni mold--preferably plain-based--and use the slugs as paper-patch cores for common 30 calibers. I've tried this stunt with 358" boolits in the 9.3mm, and it works pretty well. I might try the same regimen with 25 caliber slugs in the 6.5mm rifle later this year.

[kywoodwrkr]

http://www.neihandtools.com/
Go to 'Our Catalog"
http://www.neihandtools.com/catalog.html
Goto page 4
#36 id the 7,35 bullet.
I have a three cavity mould with #14, #36 and I think #176.
a 100 gr 244, 140 Gr 300 and a 171 gr 375 heeled .
Kind of a nice little mould but haven't fired it up yet.
DaveP kywodowrkr