C&H H press manual

[jcw1970]

Anyone out there have a scan or pdf for a C&H H press? Would like to have for reference.

[Roundnoser]

Check with CH4D. I'm sure Dave would mail one to you. Years ago, I asked him for an Auto Champ manual. He sent me one. Good guy.

[Kevin Rohrer]

Which press, the '444' or an earlier one? I'd have to check, but as I recall, when I got my '444' last year, it only came w/ a couple pages of documentation, which is available on their web site.

www.ch4d.com

[jcw1970]

It's a single. The magnum H press.

[jcw1970]

call ch4d and ordered a primer pin. no such luck on a manual.

[cassie3221]

I have recently acquired a C H Auto Champ Looking for bevel - edge rails that will allow me to reload 9mm? Any ideas where I might locate a set?

[W.R.Buchanan]

cassie: call dave at C&H he has the rails. I just bought a set a year ago.

He still has most of the replacement parts for the Auto Champ Machines. He doesn't sell the whole machine any more due to the cost of the liability ins.

Also all of you guys can get manuals from him for the asking.

Randy

[m1g]

I was given a C&H press just yesterday. It only says C&H made in U.S.A. no other numbers or anything. It is a red 3 station H press instead of 4 like the 444. It is missing one ram, clip and nut to hold the shell holders. Very smooth operation tho. I'll make use of it as a caliber specific press or something. One more can't hurt as I can always make room for more presses.

[W.R.Buchanan]

m1g: you scored! those presses routinely go for $150 + on ebay.

Once again C&H has the parts you need, and the prices for those are very reasonable.

Randy

[m1g]

W.R.Buchanan:
Yep. I went to their site and looked around.
A friend told me about this press. His friend had it and said he would sell it for $25.00 but had to dig it out. He had it stored away for several years in the garage. I was going to buy it at that price site unseen. He brought it in to work the other morning and said here. He wouldn't take any money for it.