7.5x55 Swiss

[mag_01]

:coffee: ----I have been loading the 7.5x55 without sizing the cases-No full length or neck sizing----Just knock out primers and reload---also skip the M die --not needed--seems to be working out---I think it is easier on the brass--- Maybe i will find I will have to full length size once in a while ---so far good to go----Mag

[Ricochet]

That works with the .311" boolits in my K-31 (though I do slightly flare the case mouths.) But with .308" bullets, if I don't size the necks the bullets can easily be finger-moved in the necks, and only the crimp holds them in, not a desirable condition. I'm going to try sizing to .308" when my sizing kit for that size gets here, because my chamber steps off with a perfectly square shoulder to exactly .308", no taper. Then the rifling starts. The boolit shaves down to .308", then gets squeezed from there.

[qajaq59]

That's what the guy yelled into the 15th floor window when he fell off the 60th floor roof. :-D

[mag_01]

---At that point life was good---------------mag.

[Freightman]

You just knock out the old primmer and put a new one in then reload with .311 CB? Think I will try if it is any more accurate it will be putting them in one hole!

[Ricochet]

Yeah, that works. Does shave, rather than squeeze, the boolit from .311" to .308", but they still shoot quite well.