Dillon 650 357/38 toolhead

[firebrick43]

Has any one used the tool head that a mr Williams is selling that can be used with both 357 and 38 by switching a shim on the tool head?

How is the quality? Everything line up? Does it work or do you still have to adjust the dies?

[bobthenailer]

If all the brass is trimmed to the same length per spec for 38 & 357 and you are useing the same bullet with the same crimp it should work pretty well . It may need a little fine tuning though ?
i bought a used set of 38 special dies and swap them out with the 357 dies and bought a seperate tool head for the 38 at a later date .

[Alvarez Kelly]

I agree with bobthenailer... A spare toolhead is pretty cheap compared to the special toolhead with the shim... especially if you have the extra dies.