45Dave
06-01-2005, 12:18 PM
Saw the B&M measure for sale and it brought to mind a question that I have had regarding replacement drop tubes. It would seem to me that use of some hard copper tubing with a cap soldered onto the end would make a fine tube for a single measurement. Would take some effort to cut to the correct length, but do-able. Another way would be to take some brass rod and bore it out until it took the desired charge, then mark it.
Has anyone done this with the B&M measure??
I acquired an old Pacific powder measure with a couple of brass rotors so bored and marked. This is another that could use some home made rotors. But, I have neither the equipment nor the capability to do this work.
Has anyone done this with the B&M measure??
I acquired an old Pacific powder measure with a couple of brass rotors so bored and marked. This is another that could use some home made rotors. But, I have neither the equipment nor the capability to do this work.