gofasttodd
04-18-2011, 04:09 AM
so i built a new press mount
i went to the scrap yard and and picked up a stick of 1/4x2 flat shock
so i cut s pieces at 8 inches and 2 at 6 inches and one at 10 inches
then stacked the 6 inch on top of the 8 with the 6 inch piece overlapping by 1/2 inch
and tacked on the out side edge i made 2 of these then welded the 10 inch piece across the back and drilled 2 holes 3/8ths and tapped for 3/8ths fine thread t bolts
now i can just bolt my press and sizer on a 6x1/4 piece and only have 70 cents a pound in to the whole build
nothing aluminum and fancy but gets it done
i went to the scrap yard and and picked up a stick of 1/4x2 flat shock
so i cut s pieces at 8 inches and 2 at 6 inches and one at 10 inches
then stacked the 6 inch on top of the 8 with the 6 inch piece overlapping by 1/2 inch
and tacked on the out side edge i made 2 of these then welded the 10 inch piece across the back and drilled 2 holes 3/8ths and tapped for 3/8ths fine thread t bolts
now i can just bolt my press and sizer on a 6x1/4 piece and only have 70 cents a pound in to the whole build
nothing aluminum and fancy but gets it done