cherok9878
12-11-2006, 09:32 PM
Cat, I had a problem with a stripped sprue plate pivot pin in my mould. Sent it back to Lee, they repaired it, quicker than expected.
Finally got to cast some of the boolits a few days ago, lubed and loaded today and started testing with the only powder I had on hand that may work, H110. No one in my area has LiL Gun!
Started at 15 Gr H110 in RP 357 Cases, 357 Keith sized 359, COAL 1.63(I think).
Things were mundane increasing powder by .5 gr, when I hit 16.5 everything came alive. I have a 50 yd target with a five shot group, four rounds are a ragged hole and one is .75 in high at 11 oclock. This is out of a Rossi 92 with a Williams reciever sight. I was and still am , Glowing like a teenage girl after her first kiss.
Cat, this boolit has great potential in my Rossi............Thanks
larry
Finally got to cast some of the boolits a few days ago, lubed and loaded today and started testing with the only powder I had on hand that may work, H110. No one in my area has LiL Gun!
Started at 15 Gr H110 in RP 357 Cases, 357 Keith sized 359, COAL 1.63(I think).
Things were mundane increasing powder by .5 gr, when I hit 16.5 everything came alive. I have a 50 yd target with a five shot group, four rounds are a ragged hole and one is .75 in high at 11 oclock. This is out of a Rossi 92 with a Williams reciever sight. I was and still am , Glowing like a teenage girl after her first kiss.
Cat, this boolit has great potential in my Rossi............Thanks
larry