View Full Version : Lyman Kake Kutter for .454 conical ???
geraldbergeron
12-09-2006, 08:15 PM
Hi,
I am looking for an item that seems to no more exist... ?
I would want a pan lube cutter for a .454 conical
If you know something, I would appreciate that you let me know.
Thank you for the attention......................................... ..Gerald.................../
45 2.1
12-09-2006, 08:20 PM
Send a PM Buckshot about making one. He fixed me up one for 0.575" and it works great.
Char-Gar
12-09-2006, 09:36 PM
Get you a fired 458 Mag, 460 Weatherby or similar case. Grind off the head or drill a 460 hole in the head... You now have a .454 Kake Kutter.
13Echo
12-10-2006, 06:25 PM
When pan lubing I find it a lot easier to dump the cake of lube with the bullets out onto a towel after it has cooled but is still slightly warm and then push the bullets out. Actually faster and less messy than a cake cutter.
Jerry Liles
Etienne Brule
12-19-2006, 09:25 AM
Thank you everyone,
Will try those hints.
Etienne Brűlé.
I have an old cutter made from a 45-70 case with a push rod and a handle installed. You push down over the bullet and then pop it out with the push rod. I'll try and post a picture it is the neatest cutter i have.
Etienne Brule
12-19-2006, 09:37 PM
I have an old cutter made from a 45-70 case with a push rod and a handle installed. You push down over the bullet and then pop it out with the push rod. I'll try and post a picture it is the neatest cutter i have.
Hi,
Very interested with your picture.
Thank you
Etienne.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.