3006guns
03-30-2011, 11:18 PM
I've just aquired an early (1970's) RCBS Rock Chucker. I need to disassemble the press, but I'm stuck on one thing. The lower toggle appears to be a pin with a nut to hold it......fairly obvious.....but the upper pin is flush with the link arms and in line with the ram, so it must be two pins. Has anyone taken one apart before? Sure could use some pointers!
Edit: Do you remove the lower pin and then slide the link arms off the upper pins? Could it be that simple?
Edit: Do you remove the lower pin and then slide the link arms off the upper pins? Could it be that simple?