22 derimmer help

[arjacobson]

I started turning up a 22 derimmer set tonight. Does anyone have an idea what the i.d. of the die and the o.d of the pusher stem should be.. I'm guessing the i.d.of the die should end up at about .222 and the o.d of the pusher rod should be around .199. This is basically like a lee bullet sizer setup.. Any help is much appreciated:drinks:

[arjacobson]

found it!! .218 and .198 for the punch..

[ANeat]

Are you doing the drill rod and drill bushing method??

[arjacobson]

No The shellholder/pusher is all one pc. The die is just a grade 8 bolt. Looks like I am going to bore the die out to fit a 7/32 drill bushing.. I should be able to swap them out pretty easy. I am also going to go with the replaceable pusher rod setup when mine wears out. Only problem with the drill bushing I see is they are hard as heck and will be a pain to put the taper in.... Will probably have to rig up my dremel in the lathe for an elcheapo internal grinder..