Jim
03-15-2011, 01:11 PM
Below is a photo of the receiver of my 6.5 Swedish Mauser. It is drilled and tapped in three places for scope mounts. The tooth picks are to show the hole locations.
I'd like for somebody to steer me to a place where I can get what I need as I don't know much about the right type to get. The rear most hole is 4.3 inches back from the rear hole on the forward ring and the distance between the two front holes is .850, as best I could measure with calipers.
O------4.30 "--------------------------------------------O-----.850 "-------O
I need something that will just get me by as I'm not going to put an expensive scope on this rifle. Plus, I'm on a limited budget for this kinda' stuff. If anybody can tell me where I can get an economical set of bases and rings and what to order, I sure would appreciate the help.
http://fgsp.files.wordpress.com/2011/03/photos-e1300208464594.jpg
I'd like for somebody to steer me to a place where I can get what I need as I don't know much about the right type to get. The rear most hole is 4.3 inches back from the rear hole on the forward ring and the distance between the two front holes is .850, as best I could measure with calipers.
O------4.30 "--------------------------------------------O-----.850 "-------O
I need something that will just get me by as I'm not going to put an expensive scope on this rifle. Plus, I'm on a limited budget for this kinda' stuff. If anybody can tell me where I can get an economical set of bases and rings and what to order, I sure would appreciate the help.
http://fgsp.files.wordpress.com/2011/03/photos-e1300208464594.jpg