if someone has a .311 93 grain lee mold

[tackstrp]

If some one has at lee 311-93- 1R rn mold could you tell me the length from the tip of the bullet to the beginning of the second grease groove. Tempted to buy the mold and have some one mill it down and remove one of the groove. Hope to make .311 mold near 70 grains. If some one can tell me that length may save me and the machinst heart break.

[Rangefinder]

I'm guessing you want something for 32ACP that runs closer to factory weight? I use it as-is. It seats deep, but runs really well. BUT... Since you asked: I'm showing .410 from the top of the base groove to the tip (.535 as cast OAL)

[tackstrp]

thanks so that would be as close to a winchester as i could hope for. Fellow over in longview tex said he might mill down.

pulled federal hydra shok is .419
winchester 70 grain is .409
Rimrock is .437
Hunter is .451