Corbin Ejector Pins

[deltaenterprizes]

I am told that there are 2 sizes, I have an "S" press so I can get the dimensions for that pin.
Does anybody have the press that uses the other size pin so I can get the dims fot that one?

[BLASTER62]

On the S Press there are several size's depending on caliber. 45 ACP is.120, 308 .091 223 .062 and so on.

[deltaenterprizes]

Maybe I called it the wrong name, it is the pin that goes into the frame of the press.

[Seth Hawkins]

Call Dave Corbin and get it straight from the horse's mouth, so to speak.

Phone: 541-826-5211
9am-5pm Mon-Thurs

[blaser.306]

Maybe I called it the wrong name, it is the pin that goes into the frame of the press.

I beleive that the pin you seek is the ejection pin ( not internal punch ) the dimentions are .236 diameter and the "pin" portion is 2.067 L with a knurled Knob outside of that dimention . Hope that is what you needed . I think yhe other Pin size is for the mighty mite and first series of corbin "vertical" presses that did not go thru the ram ! The other pin you seek , The short one . Is the same .236 diam and 1.056" ISH in L . close as I can measure Mine is broken in two pieces !!!

[deltaenterprizes]

I copied my pin from my "S" press since he told me he thinks his is an "S" press and made a couple for myself. Thanks for the help.

[MIBULLETS]

Yes blaser has it right. The longer pin is for the newer S press and the other pin is the same diameter but shorter and flat of the end. The older style is for use in the Mighty Mite and the older SeriesII press but can also be used in the S press. If you use older M dies in your D press it would be handy to have both pins on hand. I do. If you need the length of the short pin I can get it for you.