Searching for 50 Remington bullets or mold

[Clark]

Cartridges of the world says .508" diameter round nose 265 gr or 300 gr lead bullet.

It is for an 1871 Remington rolling block pistol.

Any information would be appreciated.

[stubshaft]

I'd just shoot a .510" boolit through it. If you don't cast, Cast Bullet Performance should have some WFNs to fit.

[Bullshop]

We have a very old Ideal mold that drops about a .510" diameter boolit that in pure lead will weigh about 300gn and in ww I think will go about 280gn.
Would be easy to run them through a custom .508" push through die.
Through a mutual friend I once sent some of these to member Mike V. This was long before castboolits though. They were intended for the same purpose as you for the Rem roller short.
I never did hear back from him about how they worked.