mikeg1005
02-19-2011, 06:13 PM
I was looking around and found that hornady makes a bulletfeeder... I will probably pick up a case feeder before I get a bullet feeder but I noticed that based on their design and the instructions... straight cast boolits aren't recommended... makes sense because if the bullets were to stick at all to anything the system would fail since they have to slide around.
Brings me to my next thing... I was thinking about shotgun shot... its got a thin film of graphite on it so that it doesn't stick.
Could the same be done for cast boolits so they feed through a bulletfeeder? Or would the graphite cause smoke/other issues?
I'm kind of thinking out loud but I figured I'd get your input on it.
MIke.
Brings me to my next thing... I was thinking about shotgun shot... its got a thin film of graphite on it so that it doesn't stick.
Could the same be done for cast boolits so they feed through a bulletfeeder? Or would the graphite cause smoke/other issues?
I'm kind of thinking out loud but I figured I'd get your input on it.
MIke.