buck1
05-26-2005, 02:25 PM
Hello everybody!
I picked up a Saeco 301 SC on ebay. It was loose so I tapped in the pins a tad & carefully filed off the hump around the pin hloes to flush. but I can see day light through the mold at the cavity from top to bottom and not ot the ends .
I guess its warped a tiny bit. I havent cast it yet. Can I clean this up with a very flat surface and a bit of fine sand paper?? any Ideas are WELCOME..... Thanks buck
I picked up a Saeco 301 SC on ebay. It was loose so I tapped in the pins a tad & carefully filed off the hump around the pin hloes to flush. but I can see day light through the mold at the cavity from top to bottom and not ot the ends .
I guess its warped a tiny bit. I havent cast it yet. Can I clean this up with a very flat surface and a bit of fine sand paper?? any Ideas are WELCOME..... Thanks buck