View Full Version : sizers...
snowman
11-11-2006, 07:42 PM
Went to an auction today. Picked up a 450 sizer with a lot of dies. I also have a 45. As well as 2 extra presses....
So...what do you prefer? Using a custom built sizer, or a sizer like the Lee setup? (I think, the 7/8 dies).
I can make the Lee type dies all day long on my lathe....as I could also make them for the 45 and 450.
My only thoughts are that I could sell the 45 and the 450 and buy a mold or two.
So...what are your opinions?
Four Fingers of Death
11-11-2006, 08:21 PM
The 450 is a newer cheaper version of the 45 isn't it? If that's the case, why not sell the 450 and hang onto the 45. I am led to believe that the RCBS is superior unit, but I think they mean in comparison to the 450.
Like to see a blow by blow account of how you make sizer dies. Buckshot did one on Lee style dies recently I believe.
If I look long enough, I will probably sell myself a lathe, etc.
snowman
11-11-2006, 08:50 PM
Do you have a link to the post from buckshot's sizer dies? I can never find it.
imashooter2
11-11-2006, 09:03 PM
The leverage on a 450 is better than a 45, so is the seal on the pressure nut (but that can be retrofitted to a 45).
Bigjohn
11-11-2006, 09:07 PM
Snowman; Try this link to Buckshots thread here on this site.
http://www.castboolits.gunloads.com/showthread.php?t=7964&highlight=sizers
John.
snowman
11-12-2006, 05:21 PM
So sell the 45, keep the 450.
Thanks for the link. Gotta get me a set of barrel laps.
Buckshot
11-13-2006, 12:51 PM
So sell the 45, keep the 450.
Thanks for the link. Gotta get me a set of barrel laps.
.............Unless you're planning on making bunches of dies, don't bother. Get some 1/2" OD aluminum rod. As you need them turn one end down to 3/8" to chuck in a drill motor, then turn the other end down (for about 2") to a size about .020" (maybe .030") under the finish die size. Use a .020" slitting saw to slit the aluminum back to the 3/8" part. Use wet or dry paper and WD40, diesel, kerosene, or paint thinner on it to hone the die to size.
..............Buckshot
snowman
11-14-2006, 01:15 AM
already got a setup like that. used to use it for polishing rings when i was doing silversmithing.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.