Lee 6cav Handle mesurments - HELP

[JTknives]

I need a few measurements off a lee 6 cav handle, mine have not shown up yet. Im finishing up the Mould block design and need to know how wide to make the handle slot and the location of the retaining screws. So ya just how thick the handle arms are and how far the hole is in from the edge to its center. I also need to know the hole size so i can see what size screw will fit into that hole. Thanks a ton!!!

[mooman76]

I don't have the best tools to measure but did the best I could with what I have. The metal is .310 thick. The hole from the end is 1/2" to the center of the hole and the hole is also .150 to center from the inside edge. I couldn't tell the exact hole size but a 5/32 bit was loose in it and the 11/64 bit was too big to fit.

[JTknives]

Thanks a ton, your numbers match the numbers another member gave me.