Mihec 434-640 HP PB Availability

[8mm]

I emailed Miha yesterday to inquire if he was planning to produce the 434-640 HP PB again. Got a reply this afternoon that he had 2 in stock. I bought 1 so for any of you that "missed the boat" like I did, here is your chance.

[EDK]

Thanks Pal

I just sent Miha an email for the other one....I hope it is a four cavity. I've been kicking myself for not ordering one. The 38 hollow base mould casts as fast as my plain base LYMAN or HENSLEY & GIBBS. I've got the LYMAN 429640, but hate to do any converting on it...hollow point or removing the gas check.... but I don't need gas checks at my preferred velocity range.

Miha does beautiful work...got a couple of his aluminum moulds and am on the list for the brass #503 and hollow base 44 wadcutter. There is no such thing as too many good moulds....I just need more money to pay for them.

:redneck::cbpour::Fire: