Dutchman
01-22-2011, 08:43 PM
This mold was a freebie. It's an older mold having the thinner sprue plate and smaller sprue countersinks. Nice condition and this is probably why. Both alignment pin holes had a raised burr around the edges.
http://images109.fotki.com/v146/photos/4/28344/9430776/DSCF2835bc-vi.jpg
The finning was so thin you could wipe it off with your finger but it was very annoying.
http://images17.fotki.com/v62/photos/4/28344/9430776/DSCF2838bc-vi.jpg
http://images58.fotki.com/v85/photos/4/28344/9430776/DSCF2833bc-vi.jpg
http://images56.fotki.com/v124/photos/4/28344/9430776/DSCF2832bc-vi.jpg
http://images54.fotki.com/v1616/photos/4/28344/9430776/DSCF2841bc-vi.jpg
Took a countersink and a couple twists by hand.
.303" nose, .314" body.
http://images57.fotki.com/v505/photos/4/28344/9430776/DSCF2856bc-vi.jpg
http://images109.fotki.com/v128/photos/4/28344/9430776/DSCF2842bc-vi.jpg
http://images109.fotki.com/v146/photos/4/28344/9430776/DSCF2835bc-vi.jpg
The finning was so thin you could wipe it off with your finger but it was very annoying.
http://images17.fotki.com/v62/photos/4/28344/9430776/DSCF2838bc-vi.jpg
http://images58.fotki.com/v85/photos/4/28344/9430776/DSCF2833bc-vi.jpg
http://images56.fotki.com/v124/photos/4/28344/9430776/DSCF2832bc-vi.jpg
http://images54.fotki.com/v1616/photos/4/28344/9430776/DSCF2841bc-vi.jpg
Took a countersink and a couple twists by hand.
.303" nose, .314" body.
http://images57.fotki.com/v505/photos/4/28344/9430776/DSCF2856bc-vi.jpg
http://images109.fotki.com/v128/photos/4/28344/9430776/DSCF2842bc-vi.jpg