Walter Laich
01-20-2011, 01:25 PM
Got two new one-cavity molds for my 45-70, the ones that cast 292 and 405 gr bullets.
Both needed cleaning up before they would drop bullets without hanging up.
I took a few burrs off with an Xaco knife then cast 5 bullets each with the spur plate open and a 3/4" nut over the hole.
When cool I coated each of them with some GoJo and put them back in the mold and turned them first by wrench then by hand. Took about 1-2 minutes for each.
Now the bullets drop out with only a light tap if any is needed at all.
They sure go through lead fast...
Both needed cleaning up before they would drop bullets without hanging up.
I took a few burrs off with an Xaco knife then cast 5 bullets each with the spur plate open and a 3/4" nut over the hole.
When cool I coated each of them with some GoJo and put them back in the mold and turned them first by wrench then by hand. Took about 1-2 minutes for each.
Now the bullets drop out with only a light tap if any is needed at all.
They sure go through lead fast...