OBXPilgrim
11-01-2006, 04:00 PM
Hello folks,
Hope nobody has recently asked about this -
Went WW scrounging today & ended up at the local recycling center. I found some ingots mixed in with some plumbers lead & wondered if any knew of this brand and/or composition.
The ingots were around 5-7 pounds each & had "I L CO" cast into the face. Looked like they were a commercial item.
Searched through the archive & didn't see anything listed.
Thanks in advance.
BTW, love the forum - went through neck surgery mid-September, had a cople disks replaced & titanium plates installed & a bone spur removed. You guys sure have made to recover interesting.
And another question - I have a couple counterweight plates that I think are pure lead. They are 18" by 18" by 2". What would be the best way to cut them down to decent size chunks to smelt into ingots?
Hope nobody has recently asked about this -
Went WW scrounging today & ended up at the local recycling center. I found some ingots mixed in with some plumbers lead & wondered if any knew of this brand and/or composition.
The ingots were around 5-7 pounds each & had "I L CO" cast into the face. Looked like they were a commercial item.
Searched through the archive & didn't see anything listed.
Thanks in advance.
BTW, love the forum - went through neck surgery mid-September, had a cople disks replaced & titanium plates installed & a bone spur removed. You guys sure have made to recover interesting.
And another question - I have a couple counterweight plates that I think are pure lead. They are 18" by 18" by 2". What would be the best way to cut them down to decent size chunks to smelt into ingots?