View Full Version : Processed a little brass today
grubbylabs
12-30-2010, 12:33 AM
Guess I need to cast a few more boolits. I sized, trimmed and primed 360 pieces of brass today, now not only am I out of large pistol primers now but my hand hurts from the hand priming tool
runfiverun
12-30-2010, 12:35 AM
get another one and use both hands....:lol:
grubbylabs
12-30-2010, 12:37 AM
get another one and use both hands....:lol:
Then I can't load the brass in the priming tool.
lwknight
12-30-2010, 12:39 AM
And I thought that I was a sucker for a cheap shot.:bigsmyl2:
geargnasher
12-30-2010, 12:49 AM
Nah, here's the cheap shot: You actually trimmed .45 ACP brass? Why? They make trimmers for those? :kidding:
Gear
grubbylabs
12-30-2010, 12:59 AM
I had to trim it, my XD is a little fussy about brass length. And to think I only have a few hundred more.
geargnasher
12-30-2010, 02:05 AM
I'm surprised, that would be one of the very few "factory" (NOT custom match) chambers I've heard of that weren't 10-15 thousandths over service length of the brass. That's actually a good thing, since it will allow your brass to actually headspace on the case mouth instead of the boolit or the extractor claw.
Gear
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.