ScottJ
12-28-2010, 12:43 AM
bought months ago off eBay.
Sort of odd results. The rear two bands in front of the gas check groove and grease groove are around .363 on average but the front two bands where the crimp grooves are measure .355-.356 on average. Guess maybe that's why it was on eBay.
Guess this doesn't really matter since the rear bands are big enough to give me seal and it is a GC design (although I'm thinking of trying them checkless in .38 Special).
My ultimate plan is to have it hollowpointed and run it at magnum velocities over slow powders. Probably with range scrap for the alloy.
Sort of odd results. The rear two bands in front of the gas check groove and grease groove are around .363 on average but the front two bands where the crimp grooves are measure .355-.356 on average. Guess maybe that's why it was on eBay.
Guess this doesn't really matter since the rear bands are big enough to give me seal and it is a GC design (although I'm thinking of trying them checkless in .38 Special).
My ultimate plan is to have it hollowpointed and run it at magnum velocities over slow powders. Probably with range scrap for the alloy.