Canuck Bob
12-27-2010, 06:57 PM
I'm confused, thats normal, but this time its worse than trying to remember my phone number.
I am setting up to cast with good ladle methods and cheap lubing with Lee push through and pan lubing.
One question remains that troubles me. If I alloy my melt and start ladling will I lose lots of tin to oxidation and fluxing? To make life bearable I'm using magnum shot and clean flashing lead plus tin solder coming in around 96-3-1 lead/antimony/tin.
Some guys say they ladle pour all day and don't lose tin and some say thier dross is full of the stuff. If I cast out of a 20# pot with clean alloy do I have to worry constantly of fluctuating tin levels?
I am setting up to cast with good ladle methods and cheap lubing with Lee push through and pan lubing.
One question remains that troubles me. If I alloy my melt and start ladling will I lose lots of tin to oxidation and fluxing? To make life bearable I'm using magnum shot and clean flashing lead plus tin solder coming in around 96-3-1 lead/antimony/tin.
Some guys say they ladle pour all day and don't lose tin and some say thier dross is full of the stuff. If I cast out of a 20# pot with clean alloy do I have to worry constantly of fluctuating tin levels?