View Full Version : Light boolit in 45/70
Freightman
12-18-2010, 11:08 AM
I was messing around yesterday during the snow and picked up a Lyman cast boolit unsized 200 gr boolit SWC and a sized 45/70 case, picked up my micrometer measured and the boolit was .458. My question is is it to light to use as a plinking load out to 100yds? I forgot to add that my bore is .457 and never had any leading with a boolit sized .458
218bee
12-18-2010, 11:29 AM
I guess my answer would be try it and find out. A light load of Unique or maybe Trail Boss should work. I use lead pistol boolits but there 240gr in my 444 Marlin and they are fun and pleasant to shoot.
Freightman
12-18-2010, 12:41 PM
Think I will when it get warm enough to go to the shop and I get over this "BUG" I have been feeding.
MtGun44
12-26-2010, 04:53 PM
Sounds like a good plinker. Try 5-10 gr of Unique for a really light load.
Bill
Catshooter
12-26-2010, 06:32 PM
Frieght,
Lots of guys shoot round balls in their 45-70s so they could work fine. Give it a try.
Cat
Don McDowell
12-26-2010, 11:17 PM
They used to use a "collar button" bullet that weighed about 150 grs for plinkin and dinkin.
excess650
12-27-2010, 08:42 AM
Lyman's 40th from 1955 lists the 457127 at 210gr and 457130 at 144gr in the 45-70. Their only listed powder charges are with Unique.
I can't really think of a reason to not try a 200-250gr bullet.
Freight man, Look at this (http://castboolits.gunloads.com/showpost.php?p=1100610&postcount=1) post.
45 2.1
12-27-2010, 11:33 AM
I was messing around yesterday during the snow and picked up a Lyman cast boolit unsized 200 gr boolit SWC and a sized 45/70 case, picked up my micrometer measured and the boolit was .458. My question is is it to light to use as a plinking load out to 100yds? I forgot to add that my bore is .457 and never had any leading with a boolit sized .458
Sure, it will work providing you use the right powder and load set up. Out to a hundred yards is probably pushing it though. 60 yards should be OK.
Larry Gibson
12-27-2010, 12:05 PM
I was messing around yesterday during the snow and picked up a Lyman cast boolit unsized 200 gr boolit SWC and a sized 45/70 case, picked up my micrometer measured and the boolit was .458. My question is is it to light to use as a plinking load out to 100yds? I forgot to add that my bore is .457 and never had any leading with a boolit sized .458
It will work very well. I shoot lots of 210 gr cast bullets over 6 gr of Bullseye for 950 fps or so out of all my 45-70s. I once had some H&G #68 205 gr SWCs that had been left in a plating solution too long and they ran .459. I loaded them over the same 6 gr of Bullseye and they shot excellently out to 300 yards. Give it a try. No filler or wad is necessary.
Larry Gibson
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.