This is probably a novice issue with an easy fix, but I'm not figuring it out.
I have a couple of Lyman 55 powder drops I got in a lot of equipment a while back. Both of the clear reservoirs are stained from use.
One of them screws off. Easy enough, I ordered a new one through Lyman. It came with no threads, but a groove cut around the circumference. No biggie, I'll see if I can clean this one up or use it as is even though it's pretty heavily stained.
The other has no threads and won't come out. I can turn it, but even pulling on it it won't come out. I'm assuming it has the same groove around the circumference and some kind of detent or something (I don't see a set screw of any kind).
Any ideas/tricks on getting this thing out? I'm assuming I'm missing something easy.
As a side note, I got them all cleaned up (they apparently sat for quite a while) and they are smooth as can be. Looking forward to putting them to good use.