jixxerbill,
If you wouldn't mind, please expand a little more on your laps (no pun intended
Are the laps made out of brass?
Do the laps have a screw at the end for adjustment?
How many slots do they have? (drawing or picture available?)
When you are using them, how do you load them up with cutting compound?
Are you doing through holes?
Have you used one in a point forming die yet?
How tight do you make them in the hole when you are using one?
Does the lap wear much?
What options does American Lap company offer?
How quickly did you get your laps?
After using a commericial lap, could you have made your own?
Thank You,
Martin