The mailman dropped off the mold today and I couldn't wait to try it out. Trued the sprue plate and milled .008" from under the attachment screw, then heat cycled it three times and it was off to the races. Whipped out 100 in no time with only two rejects. Cast using range pickups with a little tin added these dropped at 148 grains give or take a few tenths and measured just under .357". PC'd and sized to .357" I'm going to workup some 9 mil and 38 Super loads for next week. All the other Lee TC molds have been winners in my book and I don't see why these won't perform just as well.