Video of decapping 223 on my APP press using my 3d printed case feeder.

[Jim P.]

Not yet, but it would very easy to draw something up. Drawing up the bottom of these where they slide onto the original lee parts is hardest part to do and I already have that done. I just got this press at Christmas time and started decapping 223 and thats when I decided I really needed a case feeder. The single tube. I spent more time filling the tube than decapping. lol

[Jim P.]

That was not my best print. I used some filament from amazon. Not the best stuff. I have now switched brands.

[GWS]

TylerR has many APP parts to make feeding problem free. Here's the one for .357 mag.



His free downloads are here on CastBoolits in 3Dprinter section.

Here's a picture of his many downtubes:



The best part is that each downtube just drops in. Change calibers instantly, with a downtube and the proper Lee shuttle over TylerR's lower shuttle base.

This is the part the downtubes drop into. Put a long bolt through the center hole, and mount to the press.



Here's a link to the last page of his monster 3d printing thread: https://castboolits.gunloads.com/sho...llator/page139

Any of his posts has his huge stock of free 3d print .stl files.....as long as it stays free. Bottom of post "downloads" including a manual. Collators and APP parts.