I loaded up some lee 148 gr wadcutter in 38 special. I loaded like Outpost75 recommended doing. I deprimed the cases cleaned the primer pockets, primed the non sized cases and used the lee wadcutter the non tumble lube one. I lubed with 45/45/10 tumble lube and loaded them non sized at .360 right out of the mold. They shot extremely good loaded this way . I sorted out the thick brass cases when loading. I could tell about 1/30 where had to seat .thick cases even after using my Noe expander. The non sized cases the Noe expander never really touched the brass . Only the thick brass did it size ,expand.This worked really well for .360 wadcutters. I used 3.5 gr of bullseye for the load.They shoot like match ammo thanks outpost for the tip. I also didint seat them all the way flush with the case. I left them as long as I could and still fit in the cylinder. I crimped actually in the lube grove below the crimp grove.