I put it off and finally bought some plastic airgun pellets and some eastwood powder mirror blue powder.
Correct me if I am wrong here, as I notice there are multiple methods being used, but this is the gist of it:
Dump boolits, 'some' pellets and about a tablespoon of powder into a plastic container or tumbler and shake/tumble for a couple minutes.
Remove boolits and stand them up on a sheet of parchment paper and bake at 400 for 20 minutes.
Do a smash test to verify powder adheres to bullet.
THEN resize and apply gas check if so desired.
That about right?
Will be my first time trying PC, so any and all advice is welcome.
Especially if resizing is in the correct sequence, or if it is even an optional step.
If it matters, going to start with a bunch of boolits I have cast using the Lee C430-310-RF mold.